make sure your optical cables are properly magnetized / demagnetized, too
if the cables are running in a north/south direction you want them magnetized with oblong polarity to the Earth’s magnetic field, but if they’re east/west they shouldn’t be magnetized at all to avoid Maxwell-Gauss feedback loops
Nonono, only literal pure gold will ever transmit sound acceptably. If your cables are light enough to still be picked up by humans, they dont contain enough gold.
Silver is a far superior conductor, and everyone knows about the “skin effect” in wires. So obviously you want silver coated solid core copper. That’s not even getting into all the other factors involved in proper cable selection.
But the current, and therefore signal, goes on the outer side of the conductor, so you suggest the signal to go through unevenly rusted silver instead of unoxidizing in normal circumstances gold?
I’m pretty certain most will unironically say this. Or hold this up as proof that you shouldn’t use a consumer level interface because you can’t even distinguish mud from banana.
Because all those materials are shit. Only deoxydised copper with gold coating will be ok, more or less! Barbarians!
I only use gold plated banana entwined with meteorite iron, thank you very much. Everything else is just a waste of sound.
Mmmm gold plated banana entwined with meteorite iron
And optical cables need to be gold plated. Basic audiophile knowledge.
make sure your optical cables are properly magnetized / demagnetized, too
if the cables are running in a north/south direction you want them magnetized with oblong polarity to the Earth’s magnetic field, but if they’re east/west they shouldn’t be magnetized at all to avoid Maxwell-Gauss feedback loops
Nonono, only literal pure gold will ever transmit sound acceptably. If your cables are light enough to still be picked up by humans, they dont contain enough gold.
Are you part Dwarf?
Perhaps 🪨⛏
Gold!? Oh boy, where to even start …
Silver is a far superior conductor, and everyone knows about the “skin effect” in wires. So obviously you want silver coated solid core copper. That’s not even getting into all the other factors involved in proper cable selection.
I recommend these cables for the entry level audiophile.
But the current, and therefore signal, goes on the outer side of the conductor, so you suggest the signal to go through unevenly rusted silver instead of unoxidizing in normal circumstances gold?
According to the people that make the £70,470.00 speaker wires: yes.
That’s awfully specific!
I’m pretty certain most will unironically say this. Or hold this up as proof that you shouldn’t use a consumer level interface because you can’t even distinguish mud from banana.
Not unless you’ve had a swami bless it, or you may as well not have bothered.